So many browses, so many errors

[Matthew51]

NetTalk 10.40

What I'm doing is a bit confusing so I'll do my best to explain. I've run into a few and had to hack some solutions. Perhaps my solutions could be worked into NetTalk?. I have a Tag Master Browse, and inside that browse have a Tag Browse.

Problem: Only the last browse would be able to know what record to work with when the check box was clicked. The cause is all the browses have the same loc:RandomBrowseId value.
Solution: Include the parent row when calculating loc:RandomBrowseId. As I don't have an embed point right after it's set I put the following code in "Start of Procedure"

Code: [Select]

        IF p_web.GetValue('_rid_') = ''
            p_web.SetValue('_rid_', p_web.Crc32(clip(loc:parent) & lower(p_web.GetValue('_parentRow_')) & ' TagBrowse'))
        END
I also have Product Browse to the side of the Tag Master Browse.
Problem: As it is after Tag Master Browse in the code p_web.GetValue('_parentRow_') still has a value at this time. This caused the browse to not respond to any update events.
Solution: I put p_web.DeleteValue('_parentRow_') at the start of Product Browse. Perhaps a better place would have been at the end of Tag Master Browse.

If these are already fixed in NT11 you can dis regard my post.

Thank you
Matthew Leavitt

[Bruce]

Hard to comment Matthew given that you're on build 10.40, and this stuff is getting tweaked under the covers all the time.
So the code in NT 11 is already a little bit different.

but if you want to make an example app I can give it a try here and see what happens.

cheers
Bruce